Continuing from last week, I worked on the shoulder joint.

I considered various ways to reinforce the original frame parts by attaching plastic sheets, but after much deliberation, I determined that it was impossible to reinforce them with plastic sheets because the inside of the original frame is uneven.

In the end, I created a U-shaped support using two 1.5mm plastic sheets for the sides and two 2mm plastic sheets for the bottom plate, modifying it to withstand the reaction force of a 5mm inner diameter polycap (of course, it ended up like this...).

https://gn-app.com/posts/f133dc74-a567-4d99-8dc0-f84e750d4fc3
↑Previous link

Mechanic Zaku progress 6/21 | nan_koromaru21's Gunpla works